 lbjensen skrev:
føler mig lidt dum.
trykker på tallet "2" i standby. Ingenting sker |
Ved ikke hvor du har købe den, men der er et problem, at kabel der gå ned i chip printe kan løsne sig (chip fra bluraychip.dk), og så virke chip ikke, derfor skal den tilbage til forhandler.
Hvis du har den anden chip er fremgangs måde denne:
"Hardware Region & Zone Kit User Guide1. With the region & zone kit installed you will hear a beep when you first
connect the mains cable (And any subsequent time you reconnect the
mains).
2. Your player is region free for DVD and zone A for Blu-ray.
3. Note: Remember to go to Video Setup > TV System and set the TV system
to Multi-system to enable 60Hz NTSC and 50Hz PAL output. This may not
work if you use Auto output resolution since output is then controlled by
the displays EDID chip which may, for example, state max res 1080p60Hz.
In that case Auto will produce 1080p60Hz even from PAL discs. Auto is
really only there to ensure a picture on first connection. Use the resolution
that best matches your display.
4. Important Note: Region & Zone changes should be made with the player
in standby.
5. To switch to a different zone for Blu-ray, press and hold the remotes blue
button for around 5 seconds until you hear beeps, now release the blue
button and press 2 for zone B (you will hear 2 beeps), or press 3 for zone C
(you will hear 3 beeps), or to revert to zone A press 1 (you will hear 1
beep). Note: BR zone is retained till you change it again.
6. To switch to a specific region for DVD (other than region free), press and
hold the remotes red button for around 5 seconds until you hear beeps,
now release the red button and press 1 for region 1 (you will hear 1 beep),
press 2 for region 2 (you will hear 2 beeps) and so on through the 6 DVD
regions. To switch back to region free, press 0 (you will hear a long beep).
Note: DVD region retained till you change it again."
Redigeret af Startrek - 02-Maj-2010 kl. 17:14
Afspilnings problem på Oppo 83
Emne-funktioner
