mediecenter til hele huset

On the server:

1. Install DVBViewer, configure it, scan channels, make shure everything works.

2. Install Recording Service

3. In DVBViewer go to Settings>Options>Hardware and select Do not use in State section for Tuners you want to share

4. Select Start>All Programs>DVBViewer>DVBViewer Recording Service>Service Options

5. Write down the port numbers for Unicast Interface, and Control Server. Mine is 3456 and 4022

6. Tick Activate Autdiscovery, write down portnumber, usualy 600

7. In Web Settings write Username and Password

On the Client

1. Install DVBViewer.Do not install any tuners in the Setup phase

2. In DVBViewer go to Settings>Options>Hardware. Clik the + button. select the number of Unicat tuners (the number of Tuners you have shared on the server)

3. Select Normal in State for every Device

4. For each device: Click Settings. In DVB Control Server write the IP adress of the server (you can find it with Start>CMD>ipconfig on the server)

5. Do the same in DVB Unicast Device

6. Write the Control Server port, mine was 4022

7. Write Unicast  Server port, mine was 3456

8. In Autodiscovery Server list, the name of the Server should appear

9. In Options>Recording Servicetick Enable Support for Recording Service. write the IP adress of the server and the Username and password from server (point 7 above)

10. Click Test Connection. If all is okay, the name and version of Recoring Service should appear, otherwise it wil say FAILED

If everything is okay, you should now be able to scan channels on the client

If it fails, try to disable firewalls on both the server and the client