Erfaringer med Oppo BDP-83 blu-ray

Operation:

1. After installing the board, you will hear a beep when you first connect the

mains cable (And any subsequent time you reconnect the mains).

2. Your player should be region free for DVD and zone A for Blu-ray.

3. Note: Remember to go to Video Setup > TV System and set the TV system

to Multi-system to enable 60Hz NTSC and 50Hz PAL output. This may not

work if you use Auto output resolution since output is then controlled by

the displays EDID chip which may, for example, state max res 1080p60Hz.

In that case Auto will produce 1080p60Hz even from PAL discs. Auto is

really only there to ensure a picture on first connection. Use the resolution

that best matches your display.

4. Important Note: Region & Zone changes should be made with the player

in standby.

5. To switch to a different zone for Blu-ray, press and hold the remotes blue

button for around 5 seconds until you hear beeps, now release the blue

button and press 2 for zone B (you will hear 2 beeps), or press 3 for zone C

(you will hear 3 beeps), or to revert to zone A press 1 (you will hear 1

beep). Note: BR zone is retained till you change it.

6. To switch to a specific region for DVD (other than region free), press and

hold the remotes red button for around 5 seconds until you hear beeps,

now release the red button and press 1 for region 1 (you will hear 1 beep),

press 2 for region 2 (you will hear 2 beeps) and so on through the 6 DVD

regions. To switch back to region free, press 0 (you will hear a long beep).

Note: DVD region is retained till you change it.